Precontruction

We has experience with multiple building types, including steel, concrete, and wood framed. Let us help get your project off the ground. We provide the following high level of construction services for each project we take on

Specification Summary

  • Centrifugal ANSI B73.1 Process Pump Model Griswold 811M-4x3-8G, flow rate of 320 gpm  at 3000 rpm, total head 104 ft, maximum discharge pressure 45 psig
  • Baldor NEMA Motor Type 0940M, 20 hp (15kW)/ 3 phase/ 380VAC/ 4 pole/ 2925 rpm/ 50 hz, NEMA Design B, Insulation Class F, TEFC, SF1.15, 284TS Frame
  • Suction pipe size of 8 in NPS and discharge pipe size of 6 in NPS
  • The Pump Skid is equipped with MCC F2100 series Eaton Cutle Hammer 20hp, John Crane Seal Pot, Pressure Indicator

 

Code Compliance

  • API Std 610 – Centrifugal Pump for Petroleum, Petrochemical and Natural Gas Industries
  • ISO 5167-1:2003 – Measurement of fluid flow

 

We did

  • Engineering works, such-as Calculation of NPSH & Power required, Structural Skid Analysis, Shaft Coupling Selection, 3-D Modeling, Isometric Drawings, Construction Drawings, Electrical & Instrument Drawing
  • Fabrication, testing & inspection, coating of structural skid and on-skid piping
  • Installation of pump, motor and flexible coupling, including shaft alignment
  • Installation of Electrical & Instrument
  • Assembly & Install MCC F2100 series Eaton Cutler Hammer 20 HP
  • Performance test at shop

 

Safety summary

  • Total 1845 working hours
  • Lost time injury – 0
  • Day lost incident – 0
  • Near misses reported – 0

Call Center

+62 31 5000880

Head Office

Pabrick Factory, Ltd
Jalan Tuanku Abdul Rahman 50100
Kuala Lumpur, Malaysia

Telp. +61 8790 1708
Fax. +61 8790 1703

Office Hour

Mondays - Fridays
10 am - 5 pm
Image